How to Hack Wifi password using cmd

Hello Friends, In this article we will share some tricks that can help you to hack wifi password using cmd. You can experiment these trick with your neighbors or friends. It’s not necessarily that this trick will work with every wifi because of upgraded hardware. But you can still try this crack with wifi having old modems or routers. 

It’s quite easy to crack if you follow our steps carefully. This trick will work with most of the wifi devices that have old hardware( modems and routers). For general knowledge, there are two types of wifi keys WEP and WPA. Both are explained below:

1: WEP: Wired Equivalent Privacy (WEP) is one of the widely used security key in wifi devices. It is     also the oldest and most popular key and was added in 1999. WEP uses 128 bit and 256-bit                 encryption. With the help of this tutorial, you can easily get into 128-bit encryption and Hack WiFi     password using CMD.

2: WAP and WAP2: Wi-Fi Protected Access is an another version of WiFi encryption and was first       used in 2003. It uses the 256-bit encryption model and is tough to hack. WAP2 is an updated               version of WAP and was introduced in 2006. Since then it has replaced WAP and is now been used     mostly in offices and colleges worldwide.

    Below are some steps to hack wifi password using cmd. Follow them carefully and you might get      one of your neighbors passwords.

HACK WIFI PASSWORD USING CMD

Hacking a Wi-Fi device is not always easy. You have to be careful of so many steps. Otherwise, you might even get caught. For easy and secure hacking, one should use the command prompt (cmd). Cmd is one of the most used features of Windows that gives you access to almost everything on a system. If used properly, you can even get inside other remote systems.

Steps to Hack Wifi password using cmd:

1: Open command prompt by going to start and click on run command or enter windows+r, then type     cmd and hit Enter

2: In command prompt window, type

    netsh wlan show network mode=bssid

3: This command will show all the available WiFi network in your area

4: This is the last step. Just type:

      netsh wlan connect name=(wifi name )

      netsh wlan connect name=Mynet Sata1

    and you will be connected to that WiFi network.

5: To disconnect it, type

    netsh wlan disconnect

If you found this helpful then please Like & Share this post. You can also leave your questions / queries in comment section. Thanks for visiting.